Installation - W&H Multidem C27 Mode D'emploi

4. Installation

Prior to installation, read the technical data (Chapter 9) and the operating and safety information (Chapter 3).
Following storage and transportation below 0 °C, the product must be stored in the open original packaging for at least
24 hours prior to commissioning at the ambient temperatures for operation specified (Chapter 9).
Assembling the Filter Head, Water Connection
Ensure that the locking handle on the head is open.
Close water intake and switch off the power supply to the terminal device.
Fit the hoses to the water inlet »IN«  and outlet »OUT«  on the filter head .
Do not install the intake hose if there is no non-return valve on the water inlet »IN«.
Ensure that the flat seals supplied are used.
The max. tightening torque at the G3/8" connections must not exceed 14 Nm! Only hose connections
with flat seals may be used, as hoses with conical connections damage the filter head connections and
invalidate any guarantee claims!
31