Panasonic EY4541 Instructions D'utilisation page 10

WARNING:
If you do not insert the saw blade
deep enough, the saw blade may
be ejected unexpectedly during
operation. This can be extremely
dangerous.
Removal
1. Lift up the blade Attach/Remove lever.
2. Pull out the blade.
Adjusting the base
1. Use the hex wrench to loosen the
base fixing screw.
2. Move the base along the base ad-
justment hole to set its position. (See
the diagram at right.)
• The base can be adjusted to be-
tween 0° and 45° sideways and
the forward/back position can also
be adjusted. If tilting the base side-
ways, remove the dust cover first.
• Refer to the bevel index to deter-
mine the angle.
• Rip fence fixing screw should be
located on the opposite side tool
is beveled.
3. Use the hex wrench to tighten the base
fixing screw.
Position of base and purpose of use
Base adjustment
hole position
NOTE:
This is only a rough guide. The ac-
tual angle of the cut will be affected
by factors such as the way the tool is
held against the surface.
- 10 -
Purpose of use
Normal right-angled
cutting
Cutting at an angle
between 0° and 45°
Cutting at an angle of
45°
Cutting close to the end
of a wall
3
2
1
0