Installation; Connector Assignment; Mounting Guidelines; Service Notes - Dietz BOA 00906 00 Guide De L'utilisateur

Installation

Our high low adaptor 906 is perfect to tune up built- in factory systems and to upgrade existing car audio
equipment. The adaptor creates pre-out signal from the speakers output and creates +12V remote to turn on the
amplifier.

Connector assignment

Mounting Guidelines

1. Tap off the original head unit.
2. connect the speaker wires of 906 to the speaker wires of the radio.
3. connect remote with the amplifier.
4. connect line out to line in of the amplifier.
5. connect interface 906 to power.
6. build in the head unit.

Service notes

This unit does not need any servicing.
Do not open the housing. There are no user-serviceable parts inside.
Wipe gently with a dry cloth over the surface to clean the unit. If there is more tough dirt, first use a light wet
cloth and then uses a dry one. Never use corrosive cleaners to clean the unit.

Technical data

Working Voltage: 10,0 – 14,6 V DC
Stand-by current: 2 mA
Power consumption: max. 29 W
Temperature range: -40 - +85 °C
Weight: 0,080 kg
Dimensions: 80 x 40 x 25 mm
Cable length: about 200 mm
This unit is only for automotive use and has therefore a lifetime of max. 10 years.
Cable Assignment
Red Permanent +12V
2 * Ground,
short: optional
Black
Blue Remote out
White/Black Speaker left -
White Speaker left +
Grey/Black Speaker right -
Grey Speaker right +
RCA Red Right Output
RCA Black Left Output
®
Copyright © by Audiotechnik Dietz Vertriebs-GmbH ● Germany
Rev 4, Stand: 10/ 2012
English 9