For Your Safety; Operating Controls; Noise/Vibration Information - Wurth Master BS 96-A solid Notice D'utilisation

BS 96A_solid.book Seite 8 Montag, 11. Dezember 2006 1:21 13
GB
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions con-
tained therein are strictly followed.
The machine must not be damp and must also not
be operated in damp surroundings.
Be careful of hidden electrical lines or gas and wa-
ter pipes. Check the working area, e. g., with a
metal detector.
Keep long hair away from the machine. Do not op-
erate while wearing loose clothing.
Caution: The machine can begin to operate imme-
diately when the On/Off switch 4 is activated.
When replacing drill bit or battery, as well as for
transport and storage, always set the rotation di-
rection switch 5 to the centre position (lock-off).
Use a clamping device to secure the workpiece be-
fore drilling.
When working, always provide for a secure
stance.
Be careful when screwing in long screws; danger
of sliding off.
For screws, work using with a low speed.
When the battery is outside the battery charger,
cover battery terminals to avoid short circuits from
metal objects. Danger of fire and explosion!

Operating Controls

1 Keyless chuck
2 Setting ring for torque
3 Speed selector
4 On/Off switch/speed control
5 Rotation direction switch with lock-off
6 Contact surface
7 Battery
8 Ventilation slots
9 Securing screw
10 Allen key
Not all of the accessories illustrated or described are in-
cluded as standard delivery.
8

For Your Safety

Do not open the battery; protect against impact,
heat and fire. Danger of explosion!
Before each use, check the machine and battery. If
damage is detected, do not use the machine.
Have repairs performed only by a qualified tech-
nician.
Never open the machine yourself.
Battery and charger are specifically designed for
use in conjunction with one another. Charging
should be performed exclusively with a Würth rap-
id charger.
The rated voltage of the battery must correspond
with the specifications on the machine.
Convince yourself before using that the battery is
securely seated in the machine.
Always remove battery before working on ma-
chine.
Allow warm battery to cool before charging.
Under extreme conditions it is possible that some
battery fluid can escape; this, however, does not
indicate any defect. Should battery fluid contact
the skin, wash the affected parts of the skin imme-
diately with soap and water. Neutralise the battery
fluid with vinegar or lemon juice. Should any bat-
tery fluid get into the eye, rinse the eye for at least
10 minutes with fresh water. Consult a doctor im-
mediately!
Use only original Würth parts and accessories.
For further notes on safety refer to enclosed sheet.

Noise/Vibration Information

Measured values determined according to EN 60 745.
Typically the A-weighted noise levels of the machine
are: sound pressure level 78 dB (A); sound power level
89 dB (A).
Wear hearing protection!
The typical hand-arm vibration is below 2.5 m/s
2
.