Purpose; General Requirements, Warnings And Limitations - Honeywell MILLER 51/7FT Manuel De L'utilisateur

Thank You
Thank you for your purchase of Miller Fall Protection equipment. Miller brand products are
Protection equipment will provide you with years of use when cared for properly.
All persons using this equipment must read, understand and follow all instructions.
Failure to do so may result in serious injury or death. Do not use this equipment un-
less you are properly trained.
Questions?
It is crucial that the authorized person/user of this fall protection equipment read and under-
stand these instructions. In addition, it is the employer's responsibility to ensure that all users
equipment. Fall protection training should be an integral part of a comprehensive safety program.
Proper use of fall arrest systems can save lives and reduce the potential of serious injuries from
a fall. The user must be aware that forces experienced during the arrest of a fall or prolonged
suspension may cause bodily injury. Consult a physician if there is any question about the
user's ability to use this product. Pregnant women and minors must not use this product.

1.0 Purpose

The lightweight, high-strength aluminum Miller Tripod provides an easily installed anchorage for
2.0 General Requirements,
War nings and Limitations
All warnings and instructions shall be provided
to authorized persons/users.
All authorized persons/users must
reference the regulations governing
occupational safet
space regulations), as well as applicable
ANSI or CSA standards. Please refer to
product labeling for information on speci c
OSHA regulations, and ANSI and CSA
standards met by product.
All authorized persons/users of this equipment
procedures.
Us er In stru ctio ns - Engli sh
WARNING
CALL MILLER TECHNICAL SERVICE
1.800.873.5242
including con ned
Proper precautions should always be taken
to remove any obstructions, debris, material,
or other recognized hazards from the work
area that could cause injuries or interfere
with the operation of the system.
All equipment must be inspected before
each use according to the manufacturer's
instructions.
All equipment should be inspected by a
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
3