Utilitech GU8923-BZ-I Mode D'emploi page 4

ASSEMBLY INSTRUCTIONS
5. Insert the proper GU24 base 23W compact fluorescent
bulb (C) into the socket (Fig. 5). Hold the bulb (C) by its
base, insert the pins into the 2 curved slots in the bulb
socket and twist clockwise until the bulb (C) "seats". The
bulb can only go into the socket one way. Do NOT force the
bulb (C). CAUTION: DO NOT HOLD THE BULB (C) BY THE
GLASS DURING INSERTION OR REMOVAL TO PREVENT
ACCIDENTAL BREAKAGE! HOLD THE BULB (C) BY THE
PLASTIC BASE.
Re-install the diffuser (B) on the fixture (A) body. Do not
over-tighten the screws (D).
Restore power to the electrical box to make sure your fixture
(A) is working properly.
6. Your fixture (A) MUST be mounted with one of the UP
arrow ( ) symbols facing upward (Fig. 6). The arrow ( )
symbols are molded to the back surface of the housing.
7. To adjust the angle of the fixture (A), untighten the friction
lock at the side of the diffuser arm. Adjust the diffuser arm
to the proper angle, and tighten into place (Fig. 7). To
adjust the diffuser on a horizontal axis, loosen the
adjustment cog on the base of the diffuser arm and rotate
the diffuser as necessary. Retighten the adjustment cog
when the desired angle has been achieved.
OPERATING INSTRUCTIONS
Your indoor/outdoor lantern is controlled by a dusk-to-dawn photo light sensor (E). Therefore, for your
lantern to work properly, the electrical switch to the lantern MUST be turned ON at ALL times.
1. If your security light cycles ON and OFF, the
dusk-to-dawn sensor (E) may be activating due to reflected
light from a nearby surface. Place the sensor hood (DD)
firmly over the dusk-to-dawn sensor (Fig. 1). This should
prevent extraneous light from 'tripping' the dusk-to-dawn
sensor (DD).
Hardware Used
Sensor
DD
Hood
5
6
A
7
A
1
A
x 1
4
A
UP
DD
E
Lowes.com
C
A
A