Amplicomms PA 100 Mode D'emploi page 14

WARNING!
This device can generate very high volume levels and is not suitable
for users with no hearing impairment.
Commissioning/Use
1 Remove the belt clip by slightly pulling the bracket apart on the outer side
and lifting it.
2 Loosen the screw, open the battery compartment and insert the two batte-
ries as depicted in the compartment.
3 Close the battery compartment and replace the screw.
4 Remount the belt clip. Make sure the locking pins on the sides properly lock
into place in the notches on the casing.
12