Using The Tool - Panasonic EY4542 Instructions D'utilisation

Outer washer
Place the protrusion of the outer
washer into the position of the
washer.
Loosen
Tighten

Using the Tool

CAUTION:
To reduce the risk of injury read the Safety
In structions at the front of this manual before
using the tool.
WARNING
To reduce the risk of injury, wear safety gog-
gles or glasses with side shields while using the
tool. Additionally, wear a dust mask when cutting
materials that generate excessive particulate
matter. Do not use tool in the rain. Doing so may
result in electric shock or cause the tool to emit
smoke.
Do not cut materials on which there is any
paint thinner, gasoline, oil, or similar build-up.
Doing so may cause the dust case to crack,
resulting in injury.
Follow these steps:
Hold the tool with both hands. (See Fig. 8) Do
not attempt to remove cut material when blade
is moving.
EY4542(EU).indb 14
Retracting handle
Lower guard
Hex bolt
Fig. 6
1. Line up the sight line on shoe with your cut-
Alignment with cutting line
• Position the notch on the shoe over the cutting
line, aligning the top and bottom corners of the
diamond-shaped opening with the line.
As the cutting position may differ depending on
the blade, do a trial cut beforehand.
2. Press the switch lock lever down, then
- 14 -
Inner washer
Place the inner washer with cut-out
facing you.
Spindle lock button
ting line. (See Fig. 7)
Cutting line
Notch
Fig. 7
squeeze the power switch to start the motor,
and then release the switch lock lever.
2012-10-18 15:03:08