Publicité
The PM0.3d consists of an active speaker that has
a built-in amplifier and a passive speaker that does
not have an amplifier.
CD player
Personal computer or
portable music player
<Note>:Do not connect to the [INPUT A] con-
nector when you use the [INPUT B] connectors.
If you connect to the [INPUT A] connector, the
[INPUT B] connectors are disabled.
Active speaker (right channel)
This unit comprises a speaker section for playing
back right channel and a built-in stereo amplifier.
❶ [VOLUME] control
Controls the audio volume as well as turns on or off
the power.
❷ [INPUT A (L, R) ] connectors (RCA jacks)
Connect to a stereo sound source such as a CD
player and DJ mixer.
❸ [INPUT B] connector (stereo mini jack)
Connects to a stereo sound source, such as a per-
sonal computer and portable music player, using
the supplied stereo mini plug cable.
❹
[L-OUT] jack
Connects to the [L-IN] connector of the passive
speaker using the supplied speaker cable. A left
channel signal of the stereo audio source fed to the
[INPUT A] connectors or [INPUT B] connector is
sent to the passive speaker via the built-in amplifier.
❺
[DC IN] connector
Connects the supplied AC adaptor.
Functions and connections
Line
output
Headphone
output
Supplied stereo
mini plug cable
(0.8 m)
Headphone
output
<Note>:The power must be off when you make
connections.
Active speaker
❶
❷
❸
❹
❺
❻
AC adaptor
<ErP Directive>
The PM0.3d conforms to ErP directive and pursues
energy efficiency. Thus, when no-signal continues
for about 12 minutes or more, it will automatically
go into the stand-by mode and its power withdraw-
al will become as low as 0.4W. During this mode,
the power LED will change from Blue to Red.
Passive speaker (left channel)
This unit plays back left channel of the stereo audio
source fed to the active speaker.
❻
[L-IN] connector
Connects to the [L-OUT] connector of the active
speaker using the supplied speaker cable.
If you want to tilt the speakers
upward, prepare 4 pcs. feet in-
cluded in the package, peel off
the protection sheet covering
the adhesive surface of foot
and attach 2 pcs. each of feet
at the bottom of the speakers.
Especially after attaching the
feet, place the speakers at a
stable surface so that they will
not fall over.
3
Passive speaker
Supplied speaker
cable (1.5 m)
PM0.3
L-IN
to wall outlet
Attaching feet
Publicité
