Technical Specifications - Arcam T61 Mode D'emploi

Technical specifications

T61 Tuner
FM Section
Tuning range
Frequency steps
Presets: total/direct access
Sensitivity (IHF) for 50dB S/N ratio
Alternate channel selectivity
Capture ratio
Frequency response
Ultimate S/N ratio (CCIR) Mono
Stereo
Total harmonic distortion
Channel separation (1kHz)
Pilot tone suppression
Output level
AM Section
Tuning range: 10kHz step
Presets
Usable sensitivity
IF rejection
S/N ratio (30% mod., 50mV I/P)
Total harmonic distortion (30% mod., 50mV I/P)
Output level
Control inputs
IR remote standard
IR in signal level
Trigger operating voltage
Trigger in polarity
General
Output impedance
Minimum recommended load
Power consumption
Size W x D x H
Weight net
Weight packed
Supplied accessories
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products.
This means that designs and specifications are subject to
change without notice.
Mono
Stereo
9kHz step
87.5 to 108.0MHz
50kHz
30/16
typically 3µV
better than 60dB
1.5dB
20Hz–15kHz ±1dB
better than –75dB
better than –70dB
(96MHz reference, 22.5kHz deviation at 1kHz)
better than 0.1%
better than 0.2%
better than 40dB
better than 60dB
700mV at 75kHz deviation
530 to 1710 kHz
531 to 1602 kHz
16
typically 30µV
> 36dB
> 38dB
< 3%
300mV at 70% modulation
Philips RC-5, 36kHz carrier
4–15V pk-pk
9–15V DC
tip positive
220Ω
5kΩ
10VA
430 x 290 x 85mm
3.8kg
6.0kg
FM dipole aerial
AM loop aerial
mains lead
CR-389 remote control handset and batteries
NOTE: All specification values are typical unless otherwise
stated.
T61
9