Pepperl+Fuchs LAL-SRW Série Manuel page 17

ALARM SYSTEM
Installation
Oil level sensor
With a correct fluid level, the sensor must be immersed a few centimeters in the fluid. How far it
is immersed depends on the type of oil/petrol separator, the design and the capacity. The lower
section made of stainless steel must always be immersed in the fluid. The switch point of the
sensor is located between the isolated middle section and the upper metal section.
Zone 0
Figure 3.1: Mounting of oil level sensor KVF-104-PF
EN
EN - 15