Grant XUB Série Mode D'emploi page 19

Screen 5: Low power
In its factory preset mode, the Grant digital ultrasonic bath will maintain the set fluid
temperature. This means that it is consuming power when sitting idle (ie. when the
sonics are not running).
The Grant digital ultrasonic can be set to save power when not in use.
Setting Low Power to ON means that after five minutes of inactivity, the Grant digital
ultrasonic bath will enter its SLEEP mode – the screen illumination will power down,
and the internal water heater will not operate.
The Grant digital ultrasonic bath uses less than 10Watts of power whilst in SLEEP
mode.
By setting Low Power to OFF, the Grant digital ultrasonic bath screen will maintain the
set fluid temperature; i.e. when the fluid temperature falls below the specified setting,
the heaters will automatically switch on, meaning the bath is immediately ready for
use when required.
When the desired option is selected, use the MENU key to move to the next screen.
EN
17
XUB Series 29666 V1
Operating Manual