senya SYWB-BS011 Notice D'utilisation page 31

1. Remove the appliance from its packaging.
2. Plug the AC adapter into the appliance's connecting socket.
3. Plug the AC adapter into a wall socket which corresponds to the specifications of the
appliance.
4. Allow the appliance to charge for at least 10 hours.
5. When the appliance is fully charged, unplug the power cord from the socket.
6. You can then use the appliance for 40 minutes without connecting it to a mains
supply.
7. Subsequent recharging of the appliance only necessitates a duration of
approximately 8 hours. To extend the battery life of the appliance, it is
recommended to allow the battery to become completely discharged before
recharging it.
3.2. Use of the appliance
Use
This appliance is intended for smoothing out foot and heel calluses only. The appliance must
not be used on other areas of the body.
1. Before using the appliance, ensure that your feet are clean, dry and lotion-free. The
appliance must not be used on broken skin.
2. Remove the protective cover and insert a roller.
3. Press the power button on the appliance.
4. Move the appliance gently back and forth over the foot and heel calluses for 2 to 3
seconds. Do not apply too much pressure to the area being treated. This could cause
the appliance to stop working.
5. Switch off the appliance and check whether you have achieved the desired smooth
result. If necessary, repeat step 4 until the desired result has been achieved.
6. Press the on/off button to switch off the appliance.
7. Rinse your feet with warm water or use a soft towel to remove dead skin.
8. After use, clean the appliance using the brush provided.
NB:
- Discontinue use in the event of inflammation or pain.
- Do not smooth out the same area for more than 3 seconds at a time.
Changing the roller