C- Wiring / Installing; C1 - Installing; C2 - Wiring Diagram; D-To Reset The Factory Default - SCS Sentinel CodeAccess C Notice D'utilisation Et D'installation

WIrInG / InSTAllInG
C-

C1 - Installing

Wiring diagram
C2 -
To strike/electric lock
12 en
For a better seal, put silicone
on the top and the 2 sides of the
keyboard
To gate automation
D- To reSeT To FACTorY DeFAulT
a. Disconnect power from the unit
b. Press and hold # key whilst powering the unit back up
c. On hearing two "Di" release # key, system is now back factory settings
Please note only installer data is restored, user data will not be affected.

e- InDICATIonS

Operation Status
Stand by
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming mode
Open the door
Red Light Green Light Buzzer
Blinking
DI
Bright DI
DI DI DI
Bright
Bright Bright DI
Blinking DI
Bright DI
en
13