Volume Adjustment; Listening To The Radio - RCA RPD160A Manuel D'utilisation

to adjust the volume
Adjust the VOLUME level by pressing VoL+ or VoL- button.
Note: Press the MUtE button to turn off the sound (the power indicator will blink). Press the
again or press the VoL+ / - buttons to unmute.
Docking your iPod / iPhone / iPad will enable a "Speakers" option on your iPod / iPhone / iPad (you'll find it under the
"Settings" menu on your iPhone or iPad). This option enables you to control the unit's Audio EQ Presets (it doesn't
affect your iPod's / iPhone's / iPad's internal EQ Presets). The EQ Preset you chose will stay active on the unit – even
after you remove your iPod / iPhone / iPad.
Connecting to LiNE iN for other sound sources
You can connect audio devices such as your CD player or MP3 player to the unit via the LINE IN jack. To do this, connect
an audio cable from the line out or headphone out jack of the other audio device to the LINE IN jack on the rear of unit.
Ensure the unit the iPod / iPhone / iPad / LINE IN source is selected (the FM RADIO indicator should be off).
Note:
When connecting the Line-in cable to the rear of unit. Ensure the unit the iPod/iPhone/iPad/ LINE IN source is selected
(the FM RADIO indicator should be off). We recommend you unplug the device from the LiNE iN jack when not in
use.
1. Press the button to turn the unit on.
2. Press the SoURCE button to switch to FM RADIO mode (the FM indicator will turn on).
3. Tap the button to tune down radio frequency or tap the
4. Adjust the volume level.
Search to Next / Previous Station
Press and hold the /
available station.
Programming a Station to a Preset
• Use the and buttons (or
• Press and hold the SoURCE button on the remote control for 3 seconds to save it as a preset station.
Note: The unit can save up to ten stations as presets.
Selection of a Preset
Tap the / button on the remote control to select the next / previous station preset. You can also press and hold the
SoURCE button on the unit for 1-2 seconds to recall last-used preset or increment to next preset.
For Better Reception
Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds best.
Note:
• Do not connect the FM antenna to an outside antenna.
• If you wish to reset your unit to its original factory settings, please simultaneously press and hold the VoL- button
and SoURCE button for five seconds in FM mode - the unit will reset and switch to standby mode.

VoLUME ADjUStMENt

AUDio EQ PRESEtS
LiNE iN CoNNECtioN

LiStENiNG to thE RADio

button (or / button on remote control) for 2 seconds to search for next / previous
and buttons on remote control) to tune to a station.
button to tune up radio frequency.
- 5 -
MUtE button
EN