POWER SMITH PGT140 Manuel De L'opérateur page 9

ASSEMBLY AND ADJUSTMENTS
ATTACHING THE FRONT HANDLE
FIG 4
1.
Press two buttons with your fingers and hold as shown in Fig 4.
2.
Install the front handle onto the button base as shown in Fig 5.
ADJUSTING THE FRONT HANDLE (FIG 6)
The front handle can be adjusted up and down in 5 positions.
See Fig 6.
To adjust the front handle, press in the buttons (1) on both
sides and hold; adjust the handle up and down to your desired
position; release the buttons.
The handle should be adjusted so that your front arm is straight
when the trimmer is in the working position.
ADJUSTING THE HEIGHT(FIG 7)
Caution:
Adjust the length of trimmer to obtain the working
position before using the trimmer.
To adjust the height of the trimmer, loosen the shaft coupler (1)
by turning it clockwise as shown in Fig 7, move the bottom shaft
(2) up and down to the desired length, tighten the coupler by
turning it counterclockwise.
INSTALLING OR REMOVING THE BATTERY PACK (FIG 8)
iMPOrTanT!
The battery pack is not fully charged when it is purchased. Before using the product for the
first time, charge the battery pack. Make sure to read all safety precautions and follow the instructions in the Charging
Battery section.
Warning:
product is switched off before insertion or
removal of the battery pack.
• To install the battery pack, slide the battery pack onto the
bottom of the rear handle all the way until it locks in place
with a click, as shown in FIG 8. Lightly pull on the battery to
ensure it is locked into place and will not accidentally fall out
of the product.
• To remove the battery pack, pull the battery pack away from
the product while depressing the battery locking tab.
always be sure that the
English
FIG 5
FIG 6
FIG 7
9
1
1
2
FIG 8