Conrad GW INSTEK Manuel D'instructions D'utilisation page 4

Unpacking
Check all the parts for completeness and damage after unpacking.
Damaged parts must not be used for safety reasons. In case of any damage contact
our customer service.
Setting up the Device
Set up the device, using the handle or the device's pedestal, so it can be operated and read comfortably.
Avoid direct sunlight over a longer period since this could damage the screen.
In order to comply with the technical tolerance data, the device has to be operating for
about 30 minutes within the given operating temperature range.
Ensure sufficient ventilation of the device. Do not cover or seal the ventilation apertures
of the device.
Getting Started
Connect the mains cable provided to the mains connector, at the back of the device, and connect the safety
plug to an earthed mains socket.
Turn on the device using the mains switch (I/0) and the power switch ( ).
The device shows a start screen and is ready for operation after a short initialisation phase.
Connect the corresponding measuring lines/probes to the measurement input connector „RF INPUT".
The measuring signal should only be applied to the internal conductor. The external
conductor (reference earth) is connected to the earth potential (protective earth
conductor).
Touch the object to be measured with the measuring lead.
To automatically set the signal, push the button "Autoset".
With this function, all parameters are automatically adjusted optimally for the signal presentation.
Remove the lead from the object after finishing the measuring, and turn off the appliance.
Installation of the Measurement Software
Download the required Windows
Before connecting the oscilloscope to a computer, install the measuring software first.
Turn on your computer and start the operating system.
Install the software.
Connecting and installing the spectrum analyzer
Connect the USB cable to the spectrum analyzer.
The operating system detects the new hardware and starts the "Hardware Assistant". The system will
automatically search for and install appropriate drivers. The device should then be ready for use.
USB-Host
A USB flash drive can be connected at the USB-HOST under the display or on the back of the device. The
USB stick must have a FAT32 file system (not NTFS or EXT3, etc.) so that it can be recognised by the
device.
You may save data directly to a memory stick. Please refer to the detailed operating instructions for more
information.
software from www.gwinstek.com.
®
Cleaning
Always observe the following safety instructions before cleaning the device:
If you open covers or remove parts – unless you can do this by hand – live parts may
be exposed.
Prior to cleaning or repairing the device, all lines must be detached and the device must
be turned off.
Do not use scouring, chemical or aggressive cleaning agents such as benzene, alcohol or
similar chemicals. These might attack the surface of the device. Further more, the fumes are
hazardous to your health and are explosive. Moreover, you should not use sharp-edged tools,
screwdrivers or metal brushes or similar imple ments for cleaning.
Do not press too hard on the display; this can lead not only to scratches but also to the destruction of the
display. The warranty will be void!
For cleaning the device or the display and the measuring cables, use a clean, slightly damp, lint-free -,
antistatic cloth.
If there are any technical questions, please contact:
International: www.conrad.com/contact
United Kingdom: www.conrad-electronic.co.uk/contact
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2014 by Conrad Electronic SE. V1_0914_02-JH