Table des Matières
Publicité
Push the Power Button
8
again to start warming.
CAUTION: The steam given off during the warming cycle is
very hot. Do not place your hands or face near the warmer
while it is operating.
9
When the warming process is
complete, the Status Light will glow
GREEN, signifying the bottle is ready.
1
11
10
2
9
3
8
4
7
5
6
6
The Status Light will
flash GREEN and
the lights on the
1
11
Warming Light Ring
10
2
will progress
counter-clockwise
3
9
to count down the
warming cycle.
8
4
7
5
6
CAUTION: Always check the
temperature of the bottle contents
before feeding your baby.
NOTE: There are many variables
involved in bottle warming. We have
tried to eliminate much of the guess
work in the design of this product, but
you may find that you need to use a
higher or lower setting to heat the
bottle to your desired temperature.
• If bottle has not reached desired
temperature, repeat steps 4 – 9 selecting a
setting of 1 on the Dial. Do not allow bottle
to heat for full cycle. Test temperature of
bottle contents after 1 minute.
• If Status Light blinks RED, bottle warming
cycle has not been completed. This is
probably because the Water Reservoir ran
out of water prior to the end of the warming
cycle. If this happens, refill Water Reservoir
and repeat steps 4 – 9. Since bottle has
been partially heated, reset Warming Cycle
Dial to a lower setting than initially used.
• Allow at least 3 minutes for the unit to cool
before the next use. Also, check Water
Reservoir level before each use. Refill
Water Reservoir as necessary.
• The Warmer Unit will retain the last setting
unless it is unplugged. To use this setting
you can skip step 7 and go right to step 8.
COMPOSANTS :
C
Réservoir d'eau
thermique
(46573-01)
(46573-03)
D
Capuchon du
réservoir
(46573-02)
H
Cuve de
chauffe
G
Commande par
simple pression
11
Voyant d'état
10
Biberon à
9
température
ambiante
8
Anneau lumineux de
l'état d'avancement
7
du cycle de chauffe
6
MODE D'EMPLOI :
1
Brancher le
chauffe-biberon.
*Guide de
démarrage rapide
(à l'arrière du chauffe-biberons)
Blocs
E
réfrigérants
Écran
(46573-04)
A
Refroidisseur
de biberon
Chauffe-biberon
Cadran du cycle de chauffe
1
2
Bouton d'alimentation
3
4
Pour tous accessoires
et pièces de rechange,
Biberon
5
veuillez consulter
réfrigéré
notre site Web.
Poser le chauffe-biberon
sur une surface plane et
résistante à la chaleur,
hors de portée des
enfants et où il est
impossible de le
renverser ou le bouger
pendant qu'il fonctionne.
F
B
11
Publicité
Table des Matières
