Using The Remote Control - Panasonic FV-28RNQL1 Mode D'emploi Et Notice D'installation

USING THE REMOTE CONTROL

WARNING! :
Place the Range Hood away from sources of electromagnetic waves (e.g. microwave ovens), which
could interfere with the remote control and with the Range Hood electronics.
IMPORTANT :
If motor is turned on by remote control and then tuned off by electric push button of hood unit, the motor may be
turned on when pushing button of Light ON-OFF or TIMER ON on remote control, because last setting of remote
control is remained.
REMOTE CONTROL CODE CHANGE
With only one remote control, go directly to point 2.
With several remote controls in the same room, a new code can be created by following the procedure below.
Disconnect the power to the Range Hood before starting the procedure.
1) - CREATE A NEW CODE
The procedure is to be carried out on the remote control.
• Press LIGHT and TIMER
• Press DOWN on the remote control : saving is confirmed by three brief flashes of the display.
The new code cancels and replaces the previous default code.
Reconnect the Range Hood to the electrical power supply, making sure that the lights and motor are off.
2) - ASSOCIATING THE REMOTE CONTROL WITH THE RANGE HOOD USING THE ELECTRONIC PUSHBUTTON PANEL
Press TIMER ( ) on the Range Hood pushbutton panel for 2 seconds :
- The red LED lights up.
- Press any key on the remote control within 10 seconds.
RESTORING DEFAULT CODE
The procedure is to be carried out if the Range Hood is disposed of, sold or transferred.
Disconnect the power to the Range Hood before starting the procedure.
• Press UP
and DOWN
three brief flashes of the display.
• Reconnect the Range Hood to the electrical power supply.
• Proceed with associating the Range Hood and the remote control, as described in point 2.
10
DESCRIPTION OF TRANSMITTING COMMANDS
UP
Motor switch-on and speed increase from 1
to 4. Speed 4 is only active for 7 minutes.
DOWN
Speed decrease and motor switch-off.
Speed 4 Speed 3 Speed 2 Speed 1 OFF
Light ON-OFF
TIMER ON : The motor automatically
switches off after 15 min.
The function is automatically disabled if
the motor is switched off (
Command transmission active
simultaneously until the display starts flashing.
simultaneously on the remote control for more than 5 seconds : reset is confirmed by
The maximum operating distance is
5 meters, that may vary according to
the presence of electromagnetic
interferences.
Remote control operated at 433.92MHz.
The remote control consists of two parts :
- the receiver built into the Range Hood;
- the transmitter shown here in the figure.
key)