Cleaning And Maintenance; Safety Cautions - Remington STYLIST TURBO 2200 D3710 Mode D'emploi

ENGLISH
For fast drying and to remove excess moisture from hair use dryer on high heat/high
speed. For fastest air flow switch on the Turbo button 'E'.
To create smooth styles use the concentrator and a round hair brush (not included) whilst
drying.
To set the style press the cool shot button while styling. Return switch to centre position to
reactive heat.
To enhance natural curls and waves attach the diffuser to the dryer. Turn head upside down
and gently place hair into the diffuser bowl rotating the dryer in your hand slightly as you
style. Dry gently on a medium heat/low speed setting.
To create extra volume at the roots of the hair keep head upright and place the diffuser
against the top of the head gently rotate the hair dryer allowing the diffuser fingers to gently
massage the scalp. Be careful not to burn the scalp. Dry gently on a medium heat/low speed
setting.
When finished unplug the unit.
To maintain peak product performance and to prolong motor life, it is important to regularly
remove dust and dirt from the rear grille and clean with a soft brush.
To remove the rear grille for cleaning – Hold the dryer handle in one hand, then with the
other place your thumb and index finger on the indents either side of the rear grille. Pull the
rear grille away from the dryer – you can then clean this area with a soft cloth or brush.
To replace the rear grille hold in place with thumb and index finger again and click back
onto the dryer.
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF A
RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING
CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
2
110448_REM_IFU_D3710_21L.indd GB_2
CLEANING AND MA INTENANCE

SAFETY CAUTIONS

This product is not suitable for use in bath or shower.
24.06.11 16:07