Maintenance And Care - Indesit BIAAA H RW Série Mode D'emploi

Maintenance and care

Switching the appliance off
During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply.
It is not sufficient to set the temperature adjustment knobs on
(appliance off) to eliminate all electrical contact.
Cleaning the appliance
• The external and internal parts, as well as the rubber seals
may be cleaned using a sponge that has been soaked in
lukewarm water and bicarbonate of soda or neutral soap. Do
not use solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water
and soap or dishwashing liquid. Rinse and dry them
carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner
set on medium power. The appliance must be switched
off and the plug must be pulled out before cleaning the
appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors open.
Defrosting the appliance
! Follow the instructions below.
Do not speed up the defrosting process by using any devices
or tools other than the scraper provided (available only on
certain models), you may damage the refrigeration circuit.
Defrosting the refrigerator compartment
The refrigerator has an automatic defrosting function: water is
ducted to the back of the appliance by a special discharge
outlet (see diagram) where the heat produced by the
compressor causes it to evaporate. It is necessary to clean the
discharge hole regularly so that the water can flow out easily.
*
Varies by number and/or position, available only on certain
models.
MAX
WATER LEVEL
Defrosting the freezer compartment
If the frost layer is greater than 5 mm, it is necessary to defrost
manually:
1. Set the TEMPERATURE ADJUSTMENT knob to the position
.
2. Wrap frozen foods in newspaper and place them in another
freezer or in a cool place.
3. Leave the door open until the frost has melted completely.
This can be made easier by placing containers with
lukewarm water in the freezer compartment.
4. Clean and dry the freezer compartment carefully before
switching the appliance on again.
5. Certain appliances are fitted with the DRAIN SYSTEM to lead
the water outside: let the water flow into a container (see
diagram).
6. Wait for approximately 2 hours, i.e. until the ideal storage
conditions have been restored, before placing food in the
freezer compartment.
Replacing the light bulb*
To replace the light bulb in the refrigerator compartment, pull
out the plug from the electrical socket. Follow the instructions
below.Access the light bulb by removing the cover as indicated
in the diagram. Replace it with a similar light bulb within the
power range indicated on the cover (10W or 15W).
1
1
1
2
1
2
GB
13