Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 1 strip of adhesive foam th. : 5mm L : 10cm
- 1 piece of adhesive tape of protection
Assembly
- Remove the driver saddle, then the passenger saddle.
- Stick the adhesive foam on the bike and cut the surplus (see below picture).
- Remove the saddle strap, and refit the saddle on the motorbike.
- If necessary, cut and stick the provided adhesive tape between the rear shell and the edge of the
seat cowl (protection against possible scratches).
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
FITTING INSTRUCTIONS
ADAPTABLE ON Z 1000 2014 → ∞
Position of the adhesive foam
« CAUTION »
ERMAX SEAT COVER
Estimated fitting time :10 mm
Publicité
