Gardigo Isokat Midi Notice D'utilisation page 7

• The device must not be used by persons with reduced phy-
sical, sensory or mental capabilities, lack of experience and
training.
• Never put fingers or other objects into the device.
• This product is not a toy and should not be used by child-
ren. Children cannot assess the dangers involved when
dealing with electrical appliances. There is a risk of fatal
injury.
• Do not leave the packaging material lying around. This
could become a dangerous toy for children. Keep packaging
and protective films away from children. There is a risk of
suffocation.
Attention! Not for use in barns, hay storage buil-
dings or similar locations (risk of fire)!
Warning! High voltage! The device generates "high
voltage" when it is in use. Hang the device by the
preinstalled mounting ring so that the device is out
of reach. Never use the device, set it up or hang it
up so that it is within reach!
Attention! Please observe the country-specific
rules on the use of insect killers. Operation out of
doors is prohibited in Germany for environmental
protection reasons since useful insects could be
killed!
6. Replacing the illuminant
1. Turn off the device, disconnect it from the mains network
and verify that it is de-energised. Always allow the lamp to
cool off.
2. Remove the safety screw on the bottom of the device and
then remove the bottom cover (1/4 turn counter-clockwi-
se).
3. Pull off the lamp holder. Unscrew the old illuminant from
the socket and replace it with a new illuminant with the
same specifications. Mount the lamp holder.
4. Reattach the bottom cover and secure it with the screw.
Attention! The lamp may only be replaced by au-
thorised, qualified personnel!
Warning: Only use original illuminants for replacement (artic-
le no. 62307). If the illuminant has been destroyed or cannot
be unscrewed, please contact your authorised service centre.
7. Cleaning and care
Before you can begin with the cleaning and care of the device,
it has to be turned off and disconnected from the mains net-
work by pulling the mains plug. Remove the safety screw on
the bottom of the device and then remove the bottom cover
if required (1/4 turn counter-clockwise). Emptying the bowl at
weekly intervals is recommended.
Important: Before you remove the bottom cover in order to
empty it, the device must be disconnected from the mains
network by pulling the mains plug. If insects are stuck in the
mesh, only use a soft brush to remove them. After emptying
it, do not forget to reattach the bottom cover and lock it into
place by turning it clockwise. The safety screw also has to be
reinserted and tightened. Operating the device when the bot-
tom cover is not installed or the safety screw is not tightened
is prohibited. For electrical safety reasons, never use water or
other liquids for cleaning. Only use a dry, lint-free cloth and
a dry, soft brush.
8. Technical data
• Effective range: approx. 20m²
• Nominal voltage: ~230 V, 50 Hz
• Power input: approx. 4 watt
• Voltage on the mesh: approx. 1,600 volt
• I lluminant: UV lamp 230 V, 4 watt (article no. 62307)
• With on/off switch
9. General Information
1. On pass on the product in conjunction with this manual.
2. Dispose of the device, packaging and other materials in
an environmentally safe manner in accordance with appli-
cable law.
3. Use only approved extension cables
4. Avoid placing the device on the power cable
5. Protect the cable against oil, heat and sharp objects.
6. Operating or connection errors lay outside the control of
Tevigo GmbH. No liability is assumed for this.
7