for Living 088-1269-8 Mode D'emploi page 3

Place Upper Bracket (B) onto Lower Bracket (A) as
shown.
Use the S5 Allen Wrench (M) to unscrew the M6 x 20
mm Bolt (L) from Sunshade (K) by turning it
counterclockwise. Then remove Base Tube (C) from
Sunshade (K).
Line up the bolt holes on the 360° Device (G)
with the corresponding bolt holes on the two brackets.
Then screw M10 X 30 mm Bolts (D) on with Flat
Washer (F) by using S8 Allen Wrench (H). Then screw
Base Tube (C) on the 360° Device (G) with
M10 x 22mm Bolts (E) and Flat Washer (F) by
using S8 Allen Wrench (H).
Place the Cover Cap (J) on the Plastic Base Top
Cover (I), then place completed Plastic Base Top Cover
over the Base Tube (C) as shown.
Insert the Sunshade (K) onto the Base Tube (C) and
secure it by the M6x20mm Bolt (L)
Allen Wrench (M).
Open the umbrella canopy by hand. Insert Crank (N)
into the handle. Press the button on the handrail and lift
the handrail upward to raise the canopy. Release the
button to set the desired position in place.
using the S5