Denon Professional DN-202WR Guide D'utilisation page 4

4. Status Light: This LED indicates the DN-202WR's pairing status:
•
Flashing slowly (approximately once per second): DN-202WR is
not paired to a DN-202WT.
•
Flashing quickly (approximately twice per second): DN-202WR
is "searching" for a DN-202WT.
•
Solidly lit: DN-202WR is paired to a DN-202WT.
5. Level Knob: Turn this knob to set the volume of the audio signal sent
to the outputs.
6. Signal Lights: These LEDs light up when DN-202WR is receiving an
incoming audio signal from DN-202WT.
7. Outputs (Balanced XLR): Use XLR cables to connect these line-level
outputs to your audio source (loudspeakers, mixer, amplifier, etc.). See
Setup for more information.
8. Outputs (Unbalanced 1/4" / 6.35mm): Use 1/4" (6.35 mm) cables to
connect these line-level outputs to your audio source (loudspeakers,
mixer, amplifier, etc.). See
Note: For stereo operation, make sure the left (L) and right (R) inputs
are connected to left and right outputs, respectively.
4
Setup for more information.