Setting The Alarm Clock; Using The Snooze Alarm; Setting The Sleep Timer; Light Function - Grandin Radio Like CI Manuel D'utilisation

ENGLISH

SETTING THE ALARM CLOCK

Press WAKE button to select OFF, wake to buzzer or wake to radio.
1.
Press and hold WAKE button, the time start flashing.
2.
Press TUNING + button to select hour cycle from 0 to 23.
3.
Press TUNING – button to select minute cycle from 0 to 59.
4.
Just press WAKE button again to confirm, then the alarm time stops flashing and
5.
the clock appear.
The alarm (buzzer or radio) will turn on more than 2 hours if you do not stop it. To
6.
cancel the alarm clock function, just press WAKE button to select OFF and the
disappear.
Note:
– I t will auto confirm in about 7 seconds. Repeat step 1 to 4 to set the alarm clock.
– A larm clock setting is only available when the unit is in off mode.

USING THE SNOOZE ALARM

When the alarm (buzzer or radio) turns on, press the SNOOZE button and the
1.
indicator is flashing. The alarm will turn on again every 8 minutes.
To stop the snooze feature, you can refer to the section of stop/cancel alarm clock.
2.

SETTING THE SLEEP TIMER

Press the SLEEP button, the display will show 90, 80, 70, 60, 50, 40, 30, 20, 10
1.
minutes, your clock radio will turn off in the minutes you set. And the
on the display.
If you want to change the number of minutes, press the SLEEP button until the
2.
number of minutes you want appears.
To turn off the sleep timer before the time you set occurs, just press the SLEEP
3.
button until the disappears.
Note:
– I t will auto confirm in about 5 seconds. Repeat steps 1, 2 to set the sleep timer.
– S leep timer setting is only available when the unit is in on mode.
GB-10

LIGHT FUNCTION

Press the LIGHT button, the blue light will light up in about 5 seconds.
will appear.

ANTENNAS

FM
Pull out the Telescopic Antenna and adjust its Length and angle for optimum reception.
AM
The sensitive ferrite core antenna inside the set will provide excellent AM reception
in most areas. Turn the set in the direction which gives the best results because the
ferrite core antenna is directional.
SW1-2
Fully and vertically extend the telescopic antenna.

DISPOSAL OF OLD ELECTRICAL APPLIANCES

appears
The crossed out "wheeled bin" symbol on the product reminds you of your obligation,
that when you dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning
the correct disposal of their old appliance.
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must
not be disposed of in the normal unsorted municipal waste stream.
Old appliances must be collected separately in order to optimize the recovery
and recycling of the materials they contain, and reduce the impact on human
health and the environment.
ENGLISH
GB-11