Preparing For Installation; Physical Installation - Eaton Spyder 738r Manuel D'installation

Preparing for Installation

1. Open the case by removing the cover screw and pivoting the cover up from the bottom.
2. Remove the PCB by sliding the PCB up out of the PCB brackets.
3. Install one 3V CR2 Li/MnO2 battery (supplied) in the battery holder on the PCB.
Learning
1. Make sure the receiver is in learn mode (see the Installation and Programming Guide
for the receiver) before starting.
2. Make sure both back and lid tamper switches are closed.
3. Trigger either the lid or back tamper.
For receivers that use infrared learn hold the transmitter's activity LED no more than
50mm away from the infra-red learn sensor on the receiver.

Physical Installation

Mount the back
1. Hold the back in the chosen location.
2. Mark two holes through the fixing slots in the back.
3. Secure the back to the surface using the screws provided.
4. Make sure the back is flush against the surface and pushes the tamper bar in far
enough to activate the back tamper switch.
5. Re-fit the PCB into the back of the case.
8