Eurotops 29982 Mode D'emploi page 9

J 8080 / DT08
B. HOW TO USE IT
1) Insert or replace batteries
- Remove the battery cover on the back of the unit.
- Insert 2 AA batteries observing the correct polarity indicated.
- Replace the cover.
2) Operation
1) START/ PHOTOGRAPH button
2） USB connector and TF card slot
3） Camera optical lens
4) Holder
5） Telescope viewfinder
6） Battery cover
7) Video Button
USING BINDERS IN CLASSIC MODE (magnification X 10)
You can use binoculars like any other pair of binoculars. Place your eyes correctly against the
rubber, adjust the spacing of the 2 vision tubes and use the dial located above to focus. You
can also turn the dial directly on the right side viewfinder at the level of the rubber where
you place
USING BINDERS IN DIGITAL MODE (photo and video)
In digital mode, the binoculars allow you to take photos or make videos.
Attention, if you are too close or too far from the target, the quality of the photos or
videos will not be optimal.
Stand at a distance between 100 meters and 1000 meters from the target.
If you are within 100 meters of the target, the framing may be distorted: the photo or
video will be slightly shifted downwards.
1） ） ） ） Insert SD card
Insert SD card into the card slot (2)
2） ） ） ） Starting up
Keep pressing the START/PHOTOGRAPH button to start up, and the red light shines; then
the TF card is detected, and the red right flashes once when the detection succeeds, so it is
in the standby status. In this status, the red light and blue light flash alternately (with a cycle
of 2 seconds).
your eyes.
If the detection of TF card fails, the red light shines continuously, and when the blue light
flashes 8 times, it shut down; if there is not enough remaining space in the TF card, the red
light will keep shining, and the blue light will flash 8 times, then it shuts down.
3） ） ） ） Video recording function
In standby status, press the VIDEO button for a short time, this product will start video
recording. During the recording process, the blue light flash and the red light will turn off;
repress the VIDEO button for a short time to stop recording, and the blue light turns off, so it
is back to the standby status.
In the recording status, press the START/CAMERA button for a short time, this product will
save the video files. Whenever it takes a photograph, the blue light and the red light will
shine simultaneously, and the product will turn to the standby status.
In the status of recording, if the TF card does not have enough remaining space, the red light
will keep shining, and the blue light will fleetingly flash 8 times, then the product turns
power-off.
4） ） ） ） Function of photographing
In the standby status, press the START/PHOTOGRAPH button for a short time, this product
will take a photograph, and the blue light and right light will flash once simultaneously, then
this product will turn to the standby status.
5） ） ） ） Power off
When it is power-on, keep pressing the START/PHOTOGRAPH button, if it is recording a
video, the video file will be saved, and the blue light and the red light will flash five times
simultaneously , then this product will shut down; when in the standby status, if there is no
operation for five minutes, this product will shut down automatically (the blue light and the
red light flash simultaneously five times, and the product shuts down.)
6） ） ） ） Low battery voltage
When in the power-on status, if the battery voltage is too low, the blue light will keep
shining, and the red light will flash eight times, then the product shut down.
7） ） ） ） Instructions for connecting the computer
When connected to the computer, it will enter the USB mode automatically. Meanwhile, the
red light keeps shining, and the blue light flashes.
In the USB mode, press the START/PHOTOGRAPH and shift to the PC Camera function.
Meanwhile, both the the red light and the blue light keep shining.
C. TROUBLESHOUTING
1) Question: If the machine crashes, how can I reset it?