Removing/Assembling The Freezer Drawer Handle; Removing/Assembling The Doors And Drawers - LG LFXS30766 Série Manuel Du Propriétaire

Removing/Assembling the
Freezer Drawer Handle
Removing the Handles
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a / in.
4
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
1
with a / in.
8
Allen wrench.
WARNING
When assembling or disassembling the
handle:
Grasp the handle tightly to avoid dropping it.
y
Do not swing the handle into nearby people
y
or animals.
Make sure that the bracket hole of the
y
handle fits properly into the stopper bolt of
the door. Assemble the set screws to fix
the handle into place.
Make sure that there is not a gap between
y
the door and handle after assembling the
handle.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
located on the
1
/ in. Allen
8
that
at
1
/ in. Allen
4
WARNING
If your entrance door is too narrow for the
y
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
Use two or more people to remove and
y
install the refrigerator doors. Failure to do
so can result in back or other injury.
Disconnect the electrical supply to the
y
refrigerator before installing. Failure to do
so could result in serious injury or death.
Do not put hands, feet or other objects into
y
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
y
stopper, to avoid injury.
Remove food and bins before detaching the
y
doors and drawers.
INSTALLATION 13