TP-Link TL-WR802N Mode D'emploi page 15

2. The target network's SSID will be automatically filled into the
wireless setting page. Select the Security Mode and enter the
Password. Click Next and then Reboot.
Working Mode Operation Mode Wireless Setting Network Setting
Repaeter Mode setting:
Note: After the rebooting, reconnect to the network according to Instant
Wireless Connection.
WISP Client Router Mode
1. Choose your WAN Connection Type:
> If you don't know your connection type, you may select
Auto-Detect. Before continuing, you must be connected to
your existing network or modem via the LAN/WAN port.
> If you select Static IP, then enter the IP Address and Subnet
Mask given to you by your ISP, and click Next.
> If you select Dynamic IP, click Next and continue to step 2.
> If you select PPPoE/Russian PPPoE, then enter the User
Name and Password given to you by your ISP, and click Next.
> If you select L2TP/Russian L2TP, then enter the User Name
and Password given to you by your ISP, and click Next.
> If you select PPTP/Russian PPTP, then enter the User Name
and Password given to you by your ISP, and click Next.
(Also called the SSID)
:
Wireless Name of Root AP
TP-LINK_Network
MAC Address of Root AP:
94-0C-6D-2F-3C-BE
Survey
You can click the Survey Button to scan the network SSIDs,
and then choose the target one to setup the connection.
Region:
United States
Warning: Ensure you select a correct country to conform local law.
Incorrect settings may cause interference.
Auto
WDS Mode:
Wireless Security Mode:
All security settings, for example the wireless password should match the Root AP.
You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length
should be between 8 and 64 characters; for ASCII, the length should be
between 8 and 63 characters. For good security it should be of ample length
and should not be a commonly known pharse.
Back
(Also called the SSID)
Next
13
English
Finish