Entering The Vehicle While It Is Running Via Remote Start; Service Mode - Chrysler Mopar Guide De L'utilisateur

Using the Remote Control Start Function (Con't)

Entering the Vehicle While it is Running via Remote Start:

1. Unlock the vehicle doors using the remote control or key.
2. Enter the vehicle. Do not press the brake pedal.
3. Insert the key into the ignition and turn to the ON position.
4. Press the brake pedal. The remote starter disengages and the vehicle will
operate normally.
Pre-Heating or Pre-Cooling the Interior of the Vehicle:
Before exiting the vehicle, set the temperature controls to the desired setting and
operation. After the system starts the vehicle, the heater or air-conditioning will
activate and heat or cool the interior to your setting.

Service Mode:

In service mode, the remote start function is temporarily disabled to prevent the
system from unexpectedly starting the engine while being serviced.
To engage the service mode, turn the ignition key to the ON or RUN position and
press and release the button on the Mopar remote control transmitter three (3)
times. The system will pause for one second and the honk the horn three (3) times
indicating that the system is in Service mode. When attempting to activate the
remote start system while in service mode, the horn will honk three (3) times and will
not start.
To disengage the service mode, turn the ignition key to the ON or RUN position
and press and release the
(3) times. The system will pause for one second and the honk the horn one (1) time
indicating that the system has exited service mode.
Important Note: When taking your vehicle in for service, it recommended that you
inform the service personnel that your vehicle is equipped with a remote control start
system.
4
button on the Mopar remote control transmitter three