Domo DO208SW Mode D'emploi page 40

DO208SW
ASSEMbLING THE SWEEPER
Do not charge the sweeper before assembling the appliance.
1. assemble the stick by sliding the a-piece into the b-piece until the button clicks
into the hole.
2. slide the stick into the case at the top of the sweeper.
3. Make sure that the button clicks into the hole.
A
1
B
The sweeper is now ready to be charged.
CHARGING THE SWEEPER
Charge the battery during 14 to 15 hours before using the sweeper for the first
time.
• The battery is a ni-Mh battery with a voltage of 220v/50hz.
• To maintain an optimal performance of the appliance, it is recommended
to use up the battery completely and then recharge it at least every three
months.
• Do not throw the battery in fire or an environment with a high
temperature. The battery may explode.
1. Make sure that the sweeper is turned off.
2. plug the charging pin of the battery charger into the input for the charger. The
indication light will start blinking.
3. when the light stops blinking and remains lit continuously, the battery is fully
charged.
2
40
3