Combining A Message Sequence - IMG STAGELINE PML-80R Mode D'emploi

To switch off this function, press the key CANCEL (4). After
GB
an interval of approx. 25 s, the unit will return to the mode
"BANNER".

4.2.5 Combining a message sequence

Memorized messages and preprogrammed messages from
the LIBRARY data bank may be combined to a message
sequence which is displayed continuously. A maximum of 16
messages may be combined.
1) If a message is currently displayed, press the key CANCEL
(4) to stop the display.
2) First press the key SETUP (7), then the key ERASE (8).
3) Call the messages in the desired order, one after the other:
Use the memory keys M0 to M9 for messages memorized
under M0 to M9, the key BANNER (12) for the BANNER
message, the LIBRARY key (11) and the numerical keys
(5) for preprogrammed messages. The messages called
will be displayed.
4) To display the sequence as a check, press the key PLAY
(20) once.
With the key ERASE, the last message respectively dis-
played may be deleted.
5) To memorize, first press the key SETUP (7), then the key
STORE (14).
16
6) To start the continuous display of the message sequence,
press the key PLAY (20) twice.
7) To stop the continuous display, press the key CANCEL (4).
After an interval of approx. 25 s, the unit will automatically
return to the mode "BANNER".
8) With the key PLAY (20), the memorized message sequence
can be called once again:
If the key is pressed once, the sequence will be dis-
played once and after approx. 25 s the unit will return to the
mode "BANNER". If the key is pressed twice, the sequence
will be displayed continuously.
Important note:
If messages are called
with the key LIBRARY (11) and the numerical keys (5) or
with the keys M0 to M9 (16) or
with the key BANNER (12)
while a message sequence is displayed or after the display
of the message sequence has been stopped, these messages
will be added to the message sequence and will be displayed
together with the message sequence the next time. In this
case, shortly disconnect the message light from the power
supply. After setting the unit into operation and calling the
message sequence, the original sequence will be displayed
again.