LG 9GW97185D6 Mode D'emploi

LIGHTING GATEWAY
USER'S MANUAL
MANUEL D'UTILISATION
WARNING / AVERTISSEMENT
- Violation of warnings may lead to serious injury or death.
• Use the rated power. • Turn power off before installing the product.
• Do not install the product near a fire. • Do not expose the product to water.
- Le non-respect des avertissements peut entraîner des blessures graves ou la mort.
• Utilisez la puissance nominale. • Désactivez l'alimentation avant d'installer le produit.
• N'installez pas le produit près d'une source de chaleur. • N'exposez pas le produit à l'eau.
CAUTION / ATTENTION
- Violation of precautions may lead to light injury or product damage.
• Do not install on an uneven surface. • Do not disassemble or deform.
• Do not install nearby inflammable materials.
• Do not expose to direct sunlight or moisture.
- Le non-respect des avertissements peut entraîner des blessures graves ou la mort.
• Installez le produit sur une surface plane. • Ne pas démonter ou déformer le produit.
• Ne pas installer le produit à proximité de matériaux inflammables.
• Ne pas exposer le produit directement à la lumière du soleil ni à la moisissure.
ENGLISH
Dimensions
70 mm
LED Operation
Power LED
It turns on when power is applied.
LAN LED
It turns on when the LAN cable is normally connected and
the gateway communicates through the LAN.
Wireless Communication LED
It blinks regularly when the gateway is connected through
wireless communication.
Troubleshooting
The Power LED do not turn on. :
Check whether the DC cable is properly connected to both
the gateway and the adapter.
The LAN LED do not turn on. :
Check whether the LAN cable is properly connected.
The Wireless communication LED blinks too fast. :
Contact the service center or dealer that you purchased this product.
MFL68045804
29 mm
90 mm
Warranty & Customer Service
• Warranty : 1 year
• Manufacture Date : On the product
• Customer Service : www.lg.com
• Made in Vietnam
Installation
1 2
1. Connect the DC cable to the adapter.
2. Connect the DC adapter to gateway.
And then, connect the wireless router to the gateway with LAN cable.
3. Place the gateway on the proper place and make connect power.
Ensure the Power LED is on.
※Note : Initialization
Specifications
Frequency
Wireless range
Operating voltage
Current consumption
Operating temperature
Operating condition
Weight
Dimensions (WHD)
3
● Factory reset
Press and hold the reset button for over
10 seconds. After 10 seconds, all LEDs
begin flashing 3 times.
2405.0 ~ 2480.0 MHz
line of sight 98 ft (30 m)
5 V DC (from the adapter)
Max. 400 mA
-20 ~ +40℃
For Indoor use only
70 g
2.8"x3.5"x1.1" (70 mm x 90 mm x 29 mm)