IntesisHome PA-AW-WIFI-1 Guide D'installation page 6

IntesisHome ® PA-AW-WIFI-1
4.4 Placement
®
IntesisHome device needs to be placed close to the Control Panel, when there is a Monobloc system and
next to the Indoor Unit, when there is a Bibloc system (see Figure 5).
Important: Avoid placing
the device next to metal
surfaces.
Recommendations:
1. Use the top hole in the back of the IntesisHome
unit or the Control Panel (See Figure 1).
2. In order to place the device, use the holes in the back of the device to screw it. Double side tape
can also be used to fi x it. Please remember to leave enough space for the connected cables (See
Figure 1).
3. Fix the IntesisHome
Point or router). If you have coverage problems after installation, please visit the connectivity
support section in our site at www.intesishome.com/support/connectivity
5. Technical information
In order to obtain a complete and technical description of the device, please see the document at http://
www.intesishome.com/docs/PA-AW-WIFI-1-Technical-Info-eng.pdf
6. FAQ and support
For any question or problem related with the product or the installation procedure, please visit our support
center at www.intesishome.com/support .
KEEP THIS MANUAL AND THE PRODUCT
6
Important: When possible, try to check Wi-Fi coverage
in the installation location. Good Wi-Fi level is strongly
recommended.
®
device preferably as close as possible from the Wi-Fi signal source (Access
Bibloc
example
Figure 5.- IntesisHome
IMPORTANT:
ID LABEL IN A SAFE PLACE
® device to insert cables coming from the indoor
Monobloc
example
® Device and Aquarea placement
INSTALLATION GUIDE