Operation Of Wireless Remote Contro; Adjusting The Airflow - Johnson Controls YORK YHMH 20 Notice D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

OPERATION OF WIRELESS REMOTE CONTROL
About lock
Press + and - buttons simultaneously to lock or unlock the
keyboard. If the remote controller is locked, the icon
be displayed on it, will flicker for three times. If the keyboard
is unlocked, the padlock will disappear.
About swing up and down
1. Press swing up and down button continuously more than
2s,the main unit will swing back and forth from up to
down, and then loosen the button, the unit will stop
swinging and present position of guide louver will be kept
immediately.
2. Under swing up and down mode, when the status is
switched from off to , if press this button again 2s later,
status will switch to off status directly; if press this button
again within 2s,the change of swing status will also
depend on the circulation sequence stated above.
About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simulta-
neously to switch °C and °F.
Before using the fan coil, make checks and setting as
described below.
How to insert the batteries
1. Remove the battery compartment cover by sliding in the
arrow's direction;
2. Take out the old batteries;
3. Insert the new batteries (AAA 1,5V) and pay attention to
the polarity;
4. Replace the cover by sliding it into place.

ADJUSTING THE AIRFLOW

Adjusting the airflow
The vertical airflow is automatically adjusted at a certain
angle after switching on the appliance according to the
mode of operation.
The airflow direction may be adjusted as required by press-
ing the "Swing" button on the remote control.
Up and down louver swing (variable airflow)
Press the "Swing" button once. The airflow direction louvers
automatically swing up and down.
Setting the airflow direction
Press the "Swing" button again when the louvers are in the
desired position to stop their movement.
Adjusting the horizontal airflow (manual)
- Switch off the appliance
- Turn the adjusting cursors of the horizontal airflow direc-
tion louvers by hand to change the direction as shown.
Do not turn the vertical airflow direction louvers by hand as
this could cause malfunctioning. If this occurs, switch the
appliance off and then on again with the remote control.
The louvers will automatically move to the best position.
Do not keep the vertical airflow direction louvers in a
downward position for a long time in the Cooling or
Dehumidifying modes in order to avoid dripping due to
condensation.
NOTE:
- When changing the batteries, do not use the old or differ-
will
ent batteries, otherwise, it can cause the malfunction of
the wireless remote control.
- If the wireless remote control will not be used for a long
time, please take them out, and don't let the leakage liquid
damage the wireless remote control.
- If the wireless remote control can not operate normally,
please take them out, after 30s later and reinsert, if they
cannot normally run, please change them.
Cooling
Dehumidifying
Heating
Fan only
Adjusting cursors of the horizontal
airflow direction louvers
To adjust the vertical airflow, press
the SWING button.
Horizontal direction
Horizontal direction
Downwards
Downwards
User
User
19
GB

Publicité

Table des Matières
loading

Table des Matières