Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
For Mounting Under a Kitchen Cabinet (Fig 1)
1. Select preferred duct location (vertical or horizontal) if
ducting air out of kitchen. Refer to page 10 for details.
2. Begin installation by removing the fi lters (if installed).
3. Reinforce cabinet with 1"x2" wood strips if additional
strengthening is required or if cabinets are
framed.
4. Cut out the required openings for duct and electrical
access by following the dimensions on page 8;
make sure the duct opening is large enough to apply
duct tape. Refer to (Fig 2) for minimum duct cut out
dimensions
5. Position range hood in the desired mounting location
and fasten hood onto cabinet with (4) M6 wood screws
provided.
6. Install electrical.
7. Install duct work and duct tape.
8. Reinstall fi lters.
9. Power up hood and check for leaks around duct tape.
electrical
(Shown as vertical 3 1/4" x 10" ducting)
Fig 1
Back of
Cabinet
Minimum
duct cut out
Minimum duct cut out dimensions
6" Round Vertical Ducting
Width : 11"
Depth : 8"
* Depth dimensions start 1/2" from wall
Fig 2
13
Duct
opening
cutout
duct/silver
tape
Add 1x2
wood strips
C/L
Front of
Cabinet
3 1/4" x 10" Rect. Ducting
Width : 11"
Depth : 4
"
1/2
Publicité
Table des Matières
