Clamp Installation; Section 4. Start-Up And Operation - Jandy Versa-Plumb CL Série Manuel D'installation Et D'utilisation

Page 10
ENGLISH
Clamp Ring
"T" Nut and
Threaded Rod
Figure 9. Filter Clamp Ring
10. If desired, the CV filter drain can be plumbed
using a Jandy Pro universal union. The plumbing
must contain a ball valve as shown in Figure 6.
CAUTION
Be sure that all provisions for wastewater disposal
meet local, state or national codes. During any
draining process, one hundred gallons (100 gals.)
or more of pool water will be discharged. CL and CV
(Cartridge) Filters are not subject to backwashing. Do
not discharge water where it will cause flooding or
damage.
3.5

Clamp Installation

1. Be certain the o-ring is in position in the lower
tank half. Press the filter lid over the lower half
sandwiching the o-ring between the two halves.
2. Holding the ends of the filter clamp apart,
position the hinged segment of the filter clamp
over both upper and lower tank flanges. Bring the
ends of the filter clamp together.
3. Place the "T" nut and threaded rod assembly into
the clamp. Be sure the "T" nut is seated in the
clamp in the proper orientation. See Fig. 9.
4. Use a 9/16" socket on the tightening nut until
the clamp ring halves touch each other, or are
within 1/16", see Fig. 9
as the clamp can break
as indicated, do not operate the filter and
service technician immediately
5. After the first week of operation, check the clamp
and retighten if necessary.
6. Check the filter clamp at least once a month.
Jandy Versa-Plumb
®
Tightening Nut
w/ Shoulder
but do not overtighten
. If unable to tighten
call a
.
|
Cartridge Pool Filters Installation & Operation Manual
®
WARNING
Follow these instructions carefully.
Improper clamp installation can
cause product failure or also cause
the filter lid to be blown off, which
can result in death, serious personal
injury, or property damage.
Section 4. Start-Up and
Operation
NOTE This section applies to both new pool and
seasonal start-up.
1. Turn off the pump. Switch off the circuit breaker
to the pump motor.
2. Check that the drain plug for CL filters or drain
cap for CV filters is in place and tight.
3. Check that the tank clamp is correctly seated and
tight. See Figs. 9 and 10.
WARNING
NEVER start pump while standing
within five (5) feet of the filter. Starting
the pump while there is pressurized air
in the system can cause product failure
or also cause the filter lid to be blown
off, which can cause death, serious
personal injury or property damage.
WARNING
NEVER operate the filter system
at more than 50 psi of pressure.
Operating the filter system in excess
of 50 psi can cause the product failure
or also cause filter lid to be blown
off, which can cause death, serious
personal injury or property damage.
CAUTION
DO NOT operate filter at water temperatures above
105° F (40.6° C). Water temperatures above the
manufacturer's recommendations will shorten the life
span of the filter and void the warranty.
4. Open the pump hair/lint pot lid and fill the pump
basket with water to prime the system. Replace
the lid. (You may have to do this several times on
new and seasonal start-ups.)
5. Completely open the air release valve on
the gauge/air release assembly by turning
the knob on the back of the assembly fully
counterclockwise (do not remove the knob).