Setup
•
Carefully take the tower body and base out of the packaging.
•
Take the screws and washers out
•
Attach the base to the body aligning the two holes in the base with the two holes in the tower
•
Screw the base into the body
•
Stand the tower upright on the floor. The appliance is now ready for use
General operation
•
Press
to turn on or tum off the unit.
•
Press the MODE button repeatedly to select the playback source (BT, FM, SD/USB, LineIn).
•
Press and hold the VOL(Volume)+/- Buttons to adjust volume level. Press short fro NEXT/
PREVIOUS track.
•
lf the unit is not used for a long period of time, pull out the plug to turn off the unit com-
pletely.
Radio
•
Press the MODE button to select FM mode.
•
Pressing the skip buttons will make the unit search for the next station in the direction you have
chosen. It will stop and play automatically. Press PLAY/PAUSE for an automatic stations scan.
Line In
•
Connect your auxiliary device (e.g. smart phone/ MP3 player) to the 3.5mm LINE jack
•
Press the MODE button repeatedly unit the LINE indicator turn green.
•
Press Play/Pause on your auxiliary source, use VOL+/- to adjust the volume.
•
To stop playback, disconnect your auxiliary source from the LINE jack or press MODE.
USB/SD
You can connect a USB flash device or an SD card (not included) to the USB/SD ports on the
unit to play MP3 files.
•
Press MODE into the USB/SD mode.
•
USB/SD device can auto play
•
Press PREVIOUS/NEXT to select track and PLAY/PAUSE to start/stop playback.
Note:
•
Supported format: MP3 (32kbps-320kbps), WAV, WMA
•
The total number of MP3 files on the Memory Device should not exceed 999.
•
If you can't easily insert the memory card, you may have inserted it incorrectly. Try to
turn over the card and then insert again.
•
For playing files on USB flash drive, you should plug in the USB flash drive when the
unit is in standby mode. Turn ON the unit and use MODE button to select USB mode.
12
Operation