Operating Determinations; Functions - EuroLite FLASHLIGHT Mode D'emploi

There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

OPERATING DETERMINATIONS

You can install the device at any desired place. Please make sure that the device is not exposed to extreme
heat, moisture or dust. There should not be any cables lying around. You endanger your own and the safety
of others!
Do not operate the device in extremely hot (more than 30°C) or extremely cold (less than 5°C) surroundings.
Keep away from direct insolation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Caution: In order to coply with CE-standards, it is absolutely necessary to plug the filter for Geni flashtubes
between the wall socket and the controller.
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
If you want to move the device please use the original packaging in order to avoid transport damages.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
FEATURES
• Four modes with the following functions: forward, backward, reverse, crossover, autoreverse and flash.
• Speed control an frequency control via autospeed-control or via manual control through trigger-button
• Maximum charge 40 flashtubes (10 tubes per zone)
• Unlimited branching for each zone
• Rugged aluminium housing

FUNCTIONS

1. ON/OFF-switch with LED-display
2. Flash speed control
3. Function selector
4. Flash rate control
Front panel:
5