Inserting Batteries - Nikon MB-D10 Mode D'emploi

Inserting Batteries

Inserting Batteries
The MB-D10 can be used with one EN-EL3e, EN-EL4a, or EN-EL4 rechargeable Li-ion battery, or with eight AA batteries. A BL-3 battery-chamber
cover (available separately) is required when using an EN-EL4a or EN-EL4 battery.
Before inserting batteries, be sure that the camera is off and that the MB-D10 control lock is in the L position.
1 Turn the MB-D10 battery-chamber latch to
2 Ready the batteries as described below.
EN-EL3e: Matching the indentations on the battery to the projections on the MS-D10EN holder, insert the battery with the arrow (▲) on the bat-
tery toward the battery holder power terminals (Figure F- ). Press the battery lightly downward and slide it in the direction of the arrow until
the power terminals click into place (Figure F- ).
EN-EL4a/EN-EL4: If the battery release on the optional BL-3 battery-chamber cover is positioned so that the arrow ( ) is visible, slide the battery
release to cover the arrow (Figure G- ). Insert the two projections on the battery into the matching slots on the BL-3 (Figure G- ) and slide the
BL-3 battery lock release to reveal the arrow.
AA: Place eight AA batteries in the MS-D10 battery holder as shown in Figure H, making sure that the batteries are in the correct orientation.
3 Insert the battery or battery holder in the MB-D10 and latch the battery-chamber cover (Figure I). Make sure the battery or holder is fully inserted
before turning the latch.
4 Turn the camera on and check the battery level in the control panel or viewfi nder. If the camera does not turn on, check that the battery is cor-
rectly inserted.
and remove the battery holder (Figure E).
En
7