Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

14

Lighting Instructions

EN
WARNING!
WARNING!
2. Turn the burner control to the high position, press and hold in. When the burner
3. Continue to depress the burner control knob for 30 seconds and then release. If the
5. If the burner will not light with the electronic igniter, hold a lit long match or lit
6. To shut down the burner turn the burner control knob clockwise to the off position.
Then turn the gas off at the source (propane cylinder valve or natural gas supply valve).
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
for any gas to dissipate before repeating the procedure.
www.napoleongrills.com
KENS1 (GPFR) / KENS2 (GPFS)
Contol Knob
Igniter
Keep face and body away from burner area when lighting.
Ensure burner controls are in the off position. Slowly turn on the gas supply valve.
1. Press and hold electronic igniter button ( ).
lights, release the electronic igniter button.
flame goes out, repeat the procedure.
4. Adjust the flame to the desired height with the burner control knob.
long butane lighter to the ignition area of the burner and continue with step 2.
The propane cylinder is equipped with an excess flow device. Unless burners are
If the burner does not light within 10 seconds, turn the valve off and wait 5 minutes
KENS3 (GPFC40)
Igniter
Contol Knob
N415-0500 JUN 25.18

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kens2Kens3GpfrGpfsGpfc40

Table des Matières