Operation; Before Starting The Generator - Nikota 06043 Mode D'emploi

Operation

Note: The parts listings above are helpful for locating the controls
mentioned below.
CAUTION: PRIOR TO FIRST USING THE GENERATOR, THE
ENGINE MUST BE FILLED WITH APPROXIMATELY ¾ (0.63)
QUART OF A HIGH QUALITY SAE 10W-30 GRADE ENGINE
OIL. TO DO SO, UNSCREW AND REMOVE THE ENGINE'S OIL
DIPSTICK LOCATED AT THE BOTTOM OF THE ENGINE
CRANKCASE. FILL THE ENGINE'S CRANKCASE UNTIL THE
OIL LEVEL IS LEVEL WITH THE UPPER MARKED LINE ON
THE DIPSTICK. THEN, SCREW THE DIPSTICK BACK INTO
THE OIL FILL HOLE.

Before Starting the Generator

1 Check that the engine power switch
is in its "OFF" position (see diagram
on next page).
2 Before the first use, remove the fuel
tank cap and fill the fuel tank with
unleaded gasoline. Wen fueling, be
sure tha the fuel strainer is in place.
Replace the fuel tank cap.
Thereafter, check the engine's fuel
gauge for the amount of unleaded
gasoline in the fuel yank. If
necessary, refill the fuel tank with
unleaded gasoline; the generator
must be turned off and cooled down
before refilling the fuel tank.
AUTHORED BY ANTHONY HERNANDEZ (415)786-2081 - anthony94122@outlook.com
Owner's Manual
23