Maintaining and cleaning the device
8
Maintaining and cleaning the device
A
NOTICE!
Do not use any sharp or hard objects for cleaning since they may
damage the device.
➤ Disconnect from the mains.
➤ Remove the hose.
➤ Empty any remaining fluid (fig. b, page 5).
➤ Rinse out with water.
I
NOTE
You can collect the remaining fluid (approx. 30 ml) in a suitable
container and use it for the next cleaning procedure.
9
Troubleshooting
Problem
No spray formation
Fluid is leaking out of
the device
Customer service addresses are listed on the back of the manual.
28
Possible cause
Too little fluid in the device.
The ultrasonic cell is defective.
The fan is defective.
Fault in the connection to the
transformer.
Too much air-conditioning clean-
ing agent in the device.
The container is overflowing
because the device is standing
on a severe slope.
The sealing in the device is
defective.
Refresh-o-mat HD
Suggested remedy
Top up fluid.
Contact customer services.
Drain excess air-conditioning
cleaning agent from the device.
Place the device upright.
Contact customer services.
EN