How To Use; Replacing The Light Bulb - Domo DO7340H Mode D'emploi

www.domo-elektro.be DO7340H
2000W. Allow a distance of 1 metre between the heater and the closest piece of
furniture.

HOW TO USE

Read the manual carefully before using the appliance.
Turn all switches off.
Place the appliance on a flat, level, heat resistant surface.
Plug the appliance in to the electric socket.
The switches are located on the side of the appliance. You can adjust the temperature
by using these three switches.
If you see a red light it means appliance is switched on.
Switch 1: This switch activates the heating and the "fire effect". This switch must
always be switched on in order for the heater to work.
Switch 2: Heating using 1000 Watts
Switch 3: Heating using 2000 Watts. For this position, switch 2
must be used as well.

REPLACING THE LIGHT BULB

Switch the appliance completely off and remove the plug from
the electric socket.
Unscrew the screw at the back of the appliance.
Remove the cover plate. Remove the bulb and replace with
the same type of 40-Watt bulb. Put the cover plate back into
place and screw it into position correctly.
MAINTENANCE
Turn the appliance completely off and remove the plug from
the electric socket before you clean the appliance. Do not
use abrasive or aggressive cleaning agents, they can cause
damage to the appliance's varnish. Use a soft dry cloth to
remove dust and a lightly moist cloth to remove spots &
stains. Make sure that no water gets into the appliance. Thoroughly dry the appliance
thoroughly before using it.