Fitting The Batteries - Toolland BG 90007 Mode D'emploi

BG 90007
SAFE BOX
BG 90007
WARNING ! Bewaar de noodsleutel nooit in
de kluis zelf. Enkel met deze sleutel kunt u de
kluis openen wanneer u de code bent
vergeten of wanneer het systeem niet meer
functioneert vanwege lege batterijen. Bewaar
de sleutel uiteraard ook niet in de buurt van
de kluis, maar leg hem op een voor derden
onvindbare plaats.
WARNING
Read this manual carefully before using this
appliance.
PREPARATIONS
1. OPEN THE SAFE BOX
Remove the plastic cover of the lock and
insert the override key. Turn anti-clockwise,
and turn the knob clockwise to open the
door.

2. FITTING THE BATTERIES

Open the safe door and locate the battery
compartment on the rear of the door. Ensure
the new batteries are installed correctly by
testing the safe before closing the door.
3. SET THE USER CODE
Open the safe using the key then locate
•
and press the red button on the inside of
the door once. You will hear two beeps.
• Input your chosen 3-8 digit code and
press [#] to confirm.
USE
To open the safe box, input your user

code and confirm with [#]. You will hear
a beep, a green light will go on. Now turn
the knob clockwise and open the door.
WARNING : When you do not open the

door of the safe box 5 seconds after the
input of your code the system will
automatically close again. If so you need
to repeat the procedure to open the door.
WARNING : If you or an intruder uses a
wrong code the yellow light will go on. When
you use three times the wrong code the
system will freeze for 20 seconds. You need
to wait before you can retry again. When you
www.toolland.eu
uses three times again a wrong code the
system will freeze for 5 minutes.
PROBLEMS
USER CODE LOST
If you have lost your user code you can

easily open the safe box using the
emergency override key. Insert the
override key and turn it anti-clockwise to
unlock. Turn the knob clockwise en open
the door of the safe box.
EMPTY BATTERIES
If the red light goes on, it is time to

change the batteries. Open the safe door
and locate the battery compartment on
the rear of the door. Ensure the batteries
are installed correct. After changing
batteries you need to reinstall your
personal code again.
If the lock system does not work because

of low battery, use the override key to
open the safe and then replace all
batteries.
English
4