Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation with adhesive pad
• Fasten a part of the enclosed self-adhesive fastener onto antenna back.
• Fasten the other part of the enclosed fastener to the mounting surface.
• Press the antenna firmly onto the mounting surface.
Connection
The antenna cable of the antenna may be connected only to the antenna in-
puts of the corresponding receivers.
Use only the power adapter enclosed in the package in combination with the
phantom power adapter, which is also enclosed or the 5 V phantom power
supply for your receiver (if available) to supply the power.
The power adapter may only be powered by a standard mains socket that is
connected to the public supply.
The mains socket to which the power adapter is connected must be near the
device and easily accessible, so that the device can be quickly and easily
isolated from the mains power supply in the event of any fault.
Be careful when handling the mains cables and mains connectors. Mains volt-
age may cause fatal electric shocks.
Make sure that the voltage indicated on the power supply corresponds with
the mains voltage of your power supply. Never try to operate the power supply
at a different voltage.
When making the connections, make sure that the connecting cables cannot
be pinched or damaged by sharp edges.
The antenna can be powered via the included power adapter or via the phantom power of the
receiver (TV or DVB-T receiver).
Power supply via the power adapter
• Connect the antenna cable to the ANTENNA connector of the phantom power adapter.
• Connect the antenna plug of the phantom power adapter to the input of your receiver.
• Plug the low-voltage plug of the power adapter into the DC9-12V connection of the phantom
power adapter.
• Plug the power unit into the mains socket.
• As soon as the phantom power adapter is supplied with current, the red LED goes on.
Power supply via the phantom power of the receiver
• Connect the antenna cable of the antenna to the antenna input of your receiver.
• Activate the phantom power of your receiver.
Maintenance and Cleaning
• Disconnect the product from the mains supply before each cleaning procedure.
• Absolutely prevent wetness or dampness from penetrating into the device.
• Never use abrasive cleaning agents, cleaning alcohol or other chemical solutions, since the-
se could damage the housing or even impair operation.
Wall
• Use a dry, lint-free cloth to clean the product. If the device is very dirty, use a cloth slightly
moistened with lukewarm tap water.
Disposal
Electronic devices are recyclable waste materials and must not be disposed of in the
household waste.
Dispose of the unserviceable product in accordance with the relevant statutory regu-
lations.
Technical Data
Operating voltage ......................... 230 V/50 Hz (power supply)
......................................................
......................................................
Power consumption ...................... 0.2/0.9 W (standby/max.) when using a power supply
Input current ................................. 40 mA for 5 V phantom supply
Reception band ............................ 174 - 790 MHz
Amplification ................................. 14±4 dB
Connection impedance ................. 75 Ohms
Antenna cable length .................... approx. 3 m
Dimensions (W x H x D) ............... 29 x 150 x 17 mm
Weight (antenna only) .................. 70 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2016 by Conrad Electronic SE.
9 - 12 V/DC (phantom power adapter)
5 V/DC (Antenna)
1455690_V2_0716_01_VTP_m_en
Publicité
Table des Matières
