ESX SUB-D300 Mode D'emploi page 8

Please read the user's manual carefully before the installation and the first operation
of the amplifier.
SPECIFICATIONS
Output Power RMS
Output Power Max
Lowpass Filter
Subsonic Filter
Phase Shift
Bass Boost
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
IMPORTANT NOTES PRIOR TO INSTALLATION
• This device is only suited for a 12 volt system with negative ground.
• The radiated heat while operation requires sufficient air circulation at the place of installation. It is very im-
portant that the heat sink fins do not have contact with any metal parts or any surfaces which could impair
air circulation. The amplifier may not be installed in small closed location or spaces without air circulation
(e.g. spare wheel recess or below the vehicle carpeting). We recommend the installation in the vehicle's
trunk. Ensure sufficient protection against vibrations, dust and dirt.
• Ensure that the input and output cables are sufficiently separated from the power supply cables. Otherwise
interferences may occur.
• Ensure the accessibility of the fuse and the operating elements after installation.
• The reliability and performance of the amplifier depends on the quality of installation. Preferably consult an
expert to install the system.
• Avoid any damage or removing of the components of the vehicle like wires, cables, board computer, seat
belts, gas tank or the like.
8
SUB-D300
1 x 200 W @ 4 Ohms
1 x 300 W @ 2 Ohms
1 x 400 W @ 4 Ohms
1 x 600 W @ 2 Ohms
50 – 150 Hz @ 12/18dB/Octave
Fixed at 15 Hz
0° / 180°
0 – 12 dB @ 45 Hz
+12 V (9 – 15 V), negative ground
25 A
145 x 51 x 194 mm