Installation - BEGA BETEX BLF 200 Manuel Utilisateur

3. Installation

•
Remove the packaging and place the induction heater on a non-ferrous, stable and level
surface. Put heaters with wheels on the brake to prevent the heaters from moving.
•
A Betex heater is supplied with yokes, temperature sensor, heat-resistant gloves (suitable up to
250°C / 482°F) and acid-free Vaseline.
•
Check the connection voltage against the rating plate on the unit.
•
Each heater is equipped with a plug. As there is a wide variety of plug types, the attached plug
may not fit. In such cases, obtain a proper plug. It must be fitted by a qualified electrician.
There are 2 fitting options depending on the type of cable on the heater:
120V/230V 1 phase heaters
brown
blue
green/yellow
•
Ensure that the power supply cable cannot come into contact with the workpiece to be heated.
Insert the plug in a socket outlet with earth connection.
•
Switch on the device by means of the main switch. The machine briefly shows "Test", and the
display shows a "pre-set end temperature" programmed by the manufacturer.
•
Connect the temperature sensor by inserting the plug into the socket. Make sure that the – and +
of the plug correspond to that of the socket.
•
The induction heater is now ready for use in the temperature mode.
phase
zero
earth
120V/230V 1 phase heaters cCSAus
black
white
green
11
phase
zero
earth