Main Components; Displays And Controls - Solar ET8934 Mode D'emploi

ET8934_36_38_40_42.book Page 13 Thursday, July 9, 2009 9:22 AM
d
The appliance should not be installed in places where there is a risk
of it being splashed with water, such as from bathtubs, sinks,
showers, swimming pools, etc.
• Do not operate the appliance with the cable wound up.
• If the power cable is damaged, do not switch on the appliance. This
cable should only be replaced by the Technical Assistance Service in
order to prevent any risks.
• The appliance must be installed so that the switches, thermostat and
mobile power socket cannot be touched directly or indirectly by a person
in the bath or shower.
• To avoid the new smell of the appliance when using it for the first time,
switch on the emitter and leave it working for 2 hours at the highest
temperature.
q
Caution! When you wish to dispose of the appliance, NEVER throw it
in the rubbish. Instead, take it to your nearest clean point or waste
collection point, where it will receive subsequent treatment. You will
thus be helping to take care of the environment.

2 Main Components

1 Body of the heater
2 Top wall mounts (2 units)
3 Bottom wall mount
4 Screws + wall plugs for mounting (5 units + 5 units); M5x20 screws
for bottom wall mount
5 Heater fastening holes
6 Feet (ACCESSORY - NOT INCLUDED)

Displays and Controls

7 On/Off switch
8 LCD screen
9 PROG programming pushbutton
10 + Pushbutton
11 - Pushbutton
12 Start button
13 Comfort mode button
14 Economy mode button
15 Anti-frost mode button
Main Components
en
13